The unit comes with 1 CR2450 back-up battery installed to provide continuous alarm
operation and clock settings in the event of a power failure. Remove the battery pull tab
before use. When the Battery Low Icon located on the right side of the display is flashing,
it is time to replace the back-up battery. The battery compartment is located on the bottom
of the unit.
1. Please make sure the unit is connected to power source, otherwise all settings may be
lost during battery replacement.
2. Use a Phillips screwdriver to remove the battery compartment cover located on the bottom
of the unit. Remove exhausted CR2450 battery.
3. Insert a fresh CR2450 battery, checking that the + side is facing you. Replace the
compartment door.
Note: Make sure you dispose of battery properly (see your local regulations).
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high
temperatures. Do not place loose batteries in a pocket, purse, or other container containing metal objects, mix with used or
other battery types, or store with hazardous or combustible materials. Store in cool, dry, ventilated area. Follow applicable
laws and regulations for transport and disposal.
Replacing Back-up Battery
Installing Backup Battery
Using the Line-in Jack
a) Use a standard stereo audio cable with 3.5 mm plugs (available at www.ihomeaudio.com) to play your audio device
through the Line-in Jack (connect one end in the device’s line out or headphones jack, the other in the line-in jack located
on the rear of the unit).
b) Press the Power Button to turn on the unit.
c) To listen to your audio device, press the Mode Button until LINE-IN is displayed, indicating line-in mode.
d) Place your audio device in play mode.
e) Turn the Volume Knob to adjust the volume on the unit. You may need to adjust the output volume on your line-in device,
too.
f) When you are done listening, press the Power Button to turn off the unit. Remember to turn off your audio device, too.
Using Sleep Mode
Sleep mode lets you sleep to the current radio station, gradually lowering the volume until the unit shuts off at the selected time.
a) Press the Sleep Button as needed to select an amount of time before the unit shuts off: 120, 90, 60, 30 or 15 minutes, or
Off to exit sleep mode and shut the unit off.
b) Turn the Volume Wheel to set the sleep volume (this volume setting is separate from your standard volume setting).
Using the Dimmer
a) Press the Snooze/Dimmer Button during normal operation to adjust brightness of LCD display. There are several levels
of brightness including OFF.
4
Using the RT205
(15 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce